Shaper calibration

[lvlacleod]

This line near the bottom seems to delete the csv after it is created making it impossible to download. Am I missing something for a way to view the graphs? It is also present in test resonance and belt shaper

RUN_SHELL_COMMAND CMD=delete_csv

I had to commend it out to get the csv's

[TheWebMachine]

It uses the CVSs to generate PNG graphs, if I'm not mistaken.

[lvlacleod]

So where are the PNG's saved because the csv's used to be saved in /tmp/? It never used to generate PNG's for input shaper.

[Guilouz]

The CSV is of no use as such, it is just used to generate the graphs and I delete them to prevent the graphs from being generated from an old CSV.

[lvlacleod]

Where are the graphs saved. The script used to save the csv's to /tmp/. I cannot find any csv's or png's after the input shaper macro is finished

[Guilouz]

INPUT_SHAPER_CALIBRATION Macro just start calibration and save settings and not generate graphs.

TEST_RESONANCES_GRAPHS Macro is used to mesure and generate graphs in Helper-Script folder.

[TheWebMachine]

That's it! I forgot which one generated graphs and which one didn't.

[JULIANWAT]

I am a newby and have a K1C. When you run the BELTS_SHAPER_CALIBRATION you get a graph. As I SEE IT, there are two aspects of the graph. The first is the tensions on the two belts are the same hence similar peak frequencies and "simalarity" arround 95% . The second is the actual peak frequency , I ASSUME reflects the tension in the belts. WHAT SHOULD THAT FREQUENCY BE ??